Brent: bolster, first look.
Mar. 6th, 2012 09:09 amThis is really easy. First cut 'em off with Dremel and fix 'em up with pivot screw and the drill bit I used to drill the small hole yesterday.

Then I put them in a small wise so they wouldn't wiggle around, and smoothed the part which will touch the sides.

Then it came to dead stop again. The idea is to cut thread in this hole and put a screw from inside, so the head of the screw will be invisible...

I ran out of metric screws! Seriously? I have tons of 2.5, 3 and whatever in between, they all inches. Only these 4 I chose for the internals are metric, un-fucking-believable! So as I'm writing this post, I'm looking maniacly on a small pile of new sacrificial lambs - old harddrives. Yes, I took my Vix with me. :) I need 2 more, any volunteers? No? Well, let's quest then...

Then I put them in a small wise so they wouldn't wiggle around, and smoothed the part which will touch the sides.

Then it came to dead stop again. The idea is to cut thread in this hole and put a screw from inside, so the head of the screw will be invisible...

I ran out of metric screws! Seriously? I have tons of 2.5, 3 and whatever in between, they all inches. Only these 4 I chose for the internals are metric, un-fucking-believable! So as I'm writing this post, I'm looking maniacly on a small pile of new sacrificial lambs - old harddrives. Yes, I took my Vix with me. :) I need 2 more, any volunteers? No? Well, let's quest then...






